gap length

英 [ɡæp leŋθ] 美 [ɡæp leŋθ]

间隙长度

计算机



双语例句

  1. The design blasting parameters, blasting net, delay time, defending measure selection and gap length determination in complicated environment are discussed.
    探讨在复杂环境条件下爆破参数、爆破网路、延时时间、安全防护措施的选择和爆破切口范围的确定。
  2. The stress transfer model of the sensor is analyzed and the relationship between the change of Fabry-Perot gap length and hydrogen concentration is constructed.
    分析了其应力的传递过程,建立了法布里-珀罗腔腔长变化与氢浓度关系的数学模型。
  3. The analysis of this model shows that if the interelectrode gap length in the CCM elements decreases, the rate of the charge multiplication increases.
    通过对该模型的分析表明:CCM单元内电极间的间隙越小,电荷倍增率越大。
  4. Heat-sink and Package datum, Pad Spacing, Gap, Length, Width, Spread, Tweeze, Missing, Broken or Un-plated Pad.
    吸热和封装数据,衬垫间距,裂口,长度,宽度,伸展,镊子除去,缺少的,断掉的,未电镀引线。
  5. Study on Critical Gap Length of Seismic Pounding for LRB Isolated Bridges
    地震作用下LRB隔震桥梁碰撞临界间隙分析
  6. If making different time gap and sampling length at the signal collection, it would turn out different result and affect immediate judging of fault.
    讨论了故障信号采集中采样长度、时间间隔和频率的关系。
  7. When exposed to hydrogen, the palladium absorbs hydrogen and produces a change in the gap length of the sensor.
    钯在氢气环境中吸收一定量的氢并使其体积膨胀,而传感器腔长在应力的作用下发生变化。
  8. The bearing's post-yield to pre-yield stiffness ratio has little influence on critical gap length.
    隔震支座屈服前后刚度比值对临界间隙大小影响很小。
  9. When the exterior circuit was certain, the output voltage was mainly determined by the biased, but it was also affected by the chip materials, the gap length on the device resistance and the optical pulse energy to a certain extent.
    光电导开关输出电压的大小在外电路一定的条件下主要由偏置电压决定,同时开关芯片材料、开关电极间隙宽度以及触发光脉冲能量也会对其产生一定的影响。
  10. Appearance of Vacuum Arc Under Different Gap Length
    不同触头开距下真空电弧现象的研究
  11. In this paper, the method to calculate critical gap length is founded based on random vibration theory. A two span simple supported bridge with different span lengths is taken as an analyzing model, and the nonlinear restoring force of seismic isolation bearing is also considered.
    本文基于随机振动理论建立梁桥地震碰撞邻跨临界间隙的计算方法,分析模型采用跨径不等的两跨简支梁桥,且考虑隔震支座非线性恢复力的影响。
  12. Finally, rotor slot of variable frequency motor is optimum, stable-state performances and slot leakage inductance of respective rotor slot at different air gap length are calculated after motor is optimum.
    最后对变频电动机的转子槽形进行了优化设计,计算了优化后电机在不同气隙下的稳态性能和转子各槽槽漏感。
  13. Pseudorapidity Gap Length Distributions in pp Collisions at 400GeV/ c
    400GeV/cpp碰撞赝快度间隔长度分布
  14. The dimension, shap, loading direction, sampling direction, matched gap, length, loading speed, material and quantity of sample etc, 9 factors has been researched.
    试验研究了尺寸、形状、受力方向、配合间隙、试件长度、加载速度、取材方向、材料种类、试件数量等9种可能的影响因素的影响。
  15. On base of them, the relations between thrust, normal force and current magnitude, current frequency, air gap length were studied.
    在此模型基础上分析了推力、法向力与电机初级电流大小、电流频率、气隙长度之间的关系。
  16. Distincted from the Bragg gap, the photonic gap is invariant with scaling length.
    与布喇格带隙不同的是,这类光子带隙不会随着晶格常数的缩放而移动。
  17. Comparing with the conventional WEDM, the new method has the features of better WEDMed surface straightness, smaller gap length, no electrochemical corrosion and no pollution in machining, so it is suitable for WEDM finishing.
    与传统线切割加工相比,气中线切割加工技术具有加工表面直线度良好、放电间隙小、加工表面无电解腐蚀、无污染等特点,适用于电火花线切割精加工。
  18. Determination of critical gap length of seismic pounding for bridges based on random vibration theory
    基于随机振动理论确定桥梁地震碰撞的临界间隙
  19. The criterion of microroughness for self-propagating wafer bonding is studied according to JKR contact theory, where the microroughness model is based on a sinusoidal distribution for gap height and gap length.
    根据JKR接触理论,推导出晶片直接键合时晶片接触表面粗糙度需要满足的条件,其中晶片接触表面粗糙度的描述是基于缝隙长度和缝隙高度的正弦波模型。
  20. Relationship between gap width and actual defect length in rabbit femoral artery
    兔股动脉裂隙宽度与实际缺损长度的关系
  21. The rational gap length reduced the volume of adhesive effectively and the highest reduction ratio was 60%.
    合理的间隙长度可以有效地减少胶粘剂的用量,减少率最大可达60%;
  22. Determining the critical gap length between adjacent spans to avoid pounding has great significance to pounding risk prediction and designing methods to prevent pounding.
    确定梁桥邻跨间避免地震碰撞的最小间隙,对于梁桥地震碰撞危险性预测及防地震碰撞措施的设计有着显著意义。
  23. Taking the scanning wavelength as an inter-converter to compare the gap length of the sensing head with a reference length, we may obtain, in practice, a semi-absolute measurement of the sensing head length.
    用扫描波长作为中介,比较参考腔长和传感腔长,可以准绝对地测量传感腔的长度。
  24. For a Newtonian fluid, the film shrinkage increased with both draw ratio and air gap length.
    对于牛顿性流体,薄膜收缩随着拉伸比与流涎距离的增大而更加严重。
  25. Main design parameters are discussed such as electromagnetic load, flux density, air gap length, stator and rotor dimension and permanent magnet size, etc. Rotor adopts surface permanent magnet structure.
    对如何选取电磁负荷、磁通密度、气隙长度、定转子尺寸和永磁块尺寸等主要电机设计参数进行论述。
  26. We discussed in detail the gate gap length and depth of buried channel on the impact of charge-transfer efficiency.
    详细讨论了栅间隙长度和埋沟深度等参数对该CCD模型的电荷转移效率的影响。
  27. Experimental results also showed that mass transfer coefficient is affected by annular gap length and micropore size, and compared to micropore size, annular gap length has greater influence on mass transfer.
    除这两项因素外,实验同时证明传质系数也受到环隙大小和微孔大小的影响,且微孔的影响不如环隙的影响大。
  28. The influence of air cooling, draw ratio, air gap length, self-weight and viscoelasticity on the final film geometry was discussed in detail.
    重点讨论了冷却作用、拉伸比、流涎距离、自重、粘弹性等因素对薄膜形状的影响。
  29. The influences of gap length, polar arc and thick of stator yoke on electromagnetic torque are discussed.
    探讨了电机的气隙长度,定子极弧角度、定子轭厚等结构参数对电机转矩特性的影响。
  30. The load speed can be changed through adjusting the air gap length between the conductor plates and magnetic plates.
    通过调整导体盘与磁体盘之间的气隙长度,可以实现对负载的调速。